How to Install an In-dash DVD Player

Disconnect the battery on your vehicle by loosening the clamp on the black battery cable with a wench and removing the cable from its battery terminal.

Remove the trim panel surrounding the auto dvd players. Sometimes, you can just grasp and pull the panel off its clips. In many other cases, you must pry it off with a flat trim tool.

Remove the radio. The tools needed for the clips/fasteners can vary. Disconnect the wiring harness and antenna lead in the back.

Remove the steering column covers, usually by unscrewing the screws at the bottom with a screwdriver and separating the two halves, to access the wiring harness for the ignition switch/starter.

Feed the AUTO DVD PALYER‘s constant power wire (usually the yellow one) through to the engine compartment; there should be a hole in the firewall. Loosen the cable clamp for the positive battery cable, fit the wire lead on the terminal, and tighten the cable.Insert the DVD’s switched power wire — usually the red — into an available slot on the ignition switch’s wiring harness.

Mount the DVD’s black ground wire to a screw on the chassis — loosen the screw with a screwdriver, and place the wire lead under it — or a similar metal ground.

Install and fit the AUTO NAVIGATION within the dashboard where the radio was, using its fasteners and your screwdriver/wrench. Reconnect the trim panels.

Thuê xe du lịch 4,7,16,24,3... |
Barrettupmq |
Blikidigy66 |
Unblog.fr | Créer un blog | Annuaire | Signaler un abus | Provence26272
| Username13377
| Q & A: The Face Serum F...